I did a test print at 0.08mm layers, the smallest layer height I’ve attempted yet.
I used a Makergear Plastruder, and black Ultimachine 4043D PLA.
Skeinforge sliced it onto 187 layers. It was not a fast print, taking about 2.5 hours.
Aside from a kind of smeary top layer, it came out ok.
Pictures follow:
0.08mm Nophead pulley in progress.
0.08mm layers
No manual cleanup done yet.
very impressive… layers look like one of the up prints… too bad it offset on that layer 1/3 up.
That’s where the top of the set-screw hole is, so it’s a %100-solid layer. I should be able to fix that in Skeinforge.